2-1 E.D.C IMP QUESTIONS MID-I
MID-I QUESTION PAPER
SUBJECT:EDC Year and Sem: II-I
1.Derive the equation for Diode and discuss about various parameters involved in the equation.
2.Expalin the V-I characteristics of PN diode in Forward bias and Reverse bias with neat
3.Define the terms given below
a) Diffusion current b)Drift current c)Reverse saturation current d) cut in voltage
e) Barrier potential.
4.a)Explain Zener diode characteristics in reverse bias
b)Determine forward current in case of PN junction diode with I0=10micro amps,Vf=0.8V,
at T=3000k,Assume silicon diode.
5.Write the differences between
a) Zener Break down and Avalanche breakdown
b) Zener diode and PN diode
1.Explain Full wave rectifier operation and derive all the necessary parameters of FWR.
2.Determine a)D.C. output voltage b) PIV c)Rectifier efficiency of FWR with Ep(rms)=230V
3.Derive the ripple factor of π-filter with neat sketch.
4.Draw the block diagram of Regulated power supply and explain its operation
5.a)Comparison of Filter circuits(L,C,LC,π filters)
b)Comparison between FWR using 2 diodes and 4 diodes.
1.a)What is early effect ? how it it modify the V-I characteristics of BJT
b)CalculateIc and IE for a transistor with αd.c=0.99 and ICB0=5microamps,IB=20microamps
2.Explain the input output characteristics of common base configuration with neat sketches
3.a)Why CE circuit if preferred than CB
b) Differences between CB,CE,CC configurations
4.Explain the input output characteristics of common emitter configuration with neat sketches
5.a)Define a transistor? Types of BJTs with symbols
b)Relation between αd.c andβd.c
1.Derive the stability factors S,S’,S” and what is the need of this in BJT circuits and obtain the
Equation of it.
2.Explain the D.C load line analysis of CE amplifier.
3.a)What is the need of biasing.
b)Explain the parameters which are effecting the operating point
4.Explain Fixed bias operation & find S,S’,S” for the same.
5.Draw D.C load line and A.C load line for a CE amplifier with Vcc=12V,R1=8KΩ,R2=4KΩ,
- Posts: 21
Join date: 2011-08-21
Permissions in this forum:You cannot reply to topics in this forum